About this Product
Dyco 7200 Cement Paver Sealer is a solvent acrylic, nonyellowing clear sealer for sealing non-sealed or coated pavers. Paver Sealer gives a wet-look and enhances the true color of the paver. How to determine if your pavers have been sealed with a latex water base sealer: Test the surfaces by pouring a small amount of water on the surface. If it penetrates quickly, the surface is porous and ready for 7200 Paver Sealer. If it does NOT and takes 2-20 minutes to penetrate, then DO NOT apply 7200 Paver Sealer.
• Concrete Cement Pavers
• Resists Tire Marking
• Resists Mildew
• Resists Cracking & Peeling
• Easy To Apply
SPECIAL NOTE: DANGER! EXTREMELY FLAMMABLE! CONTAINS XYLENE! See instructions on reverse side or label for details
PRECAUTION: Do not freeze. Wear protective clothing, gloves and eyewear during application and cleanup of this product. Do not transport on passenger seats or inside passenger compartment of any vehicle. Store product in cargo area of vehicle, and secure with protective cloths to prevent accidental spill damage. Do not store at temperature above 100°F (37.77°C). Do not use in drinking water or food systems. DO NOT apply in temperatures below 50° F to a damp surface. On excessively hot surfaces, for example direct sunlight on a hot day, drying may occur too rapidly, causing trapped vapors to bubble. If this occurs, we recommend application during a cooler time of day. Keep away from children. Keep away from direct heat and open flame. This product is not recommended for wood or Bominite surfaces. Close container after each use.
MIXING: Stir form bottom with vigorous strokes. Do not add oil or other paints.
APPLICATION: On bare pavers, the surface must be clean, dry, and free of all grease, oil, and dirt. If necessary, clean with a good degreaser and brush, and/or pressure wash for best results. When applying use a short nap solvent resistant roller cover (3/8” Nap). Apply evenly, and do not leave puddles or roller marks. Dip roller cover into the Paver Sealer and roll forward allowing wet sealer in front of the roller to penetrate the deeper crevices around the paver. Do not dry roll, keep plenty of sealer on roller cover. Do not apply to areas where standing water is evident. If there has been a skid-texture added to the sealer, this product may perform properly but all precautions must be taken. On bare concrete, the surface must be clean and dry.
DRY TIME: Surface will be tack free in 1 hour, ready for foot traffic in 2 hours and vehicle traffic in 72 hours. COVERAGE: Recommended coverage is 100-125 sq. ft. per gallon. Actual coverage may vary depending on substrate and application method.
Refer to Safety Data Sheet for additional health and safety information.
Refer to Product Spec Sheet for additional application details and further information.
- Choosing a selection results in a full page refresh.
- Press the space key then arrow keys to make a selection.