About this Product
Dyco® TUFF GRIP™ is a waterborne epoxy ester tie coat formulated to penetrate, fortify and prepare slick steel troweled non-porous bare concrete. This product is also a superior bonding primer for previously painted deck surfaces.
FOR USE ON: Concrete and wood surfaces usually found in driveways, garages, walkways, patios, pool decks, docks, steps and ramps.
Product Specifications:
- Detailed Specifications
- Product Insights
- Product Features
- Usage Instructions
- Resources
- Product Reviews
Dyco® TUFF GRIP™ is a waterborne epoxy ester tie coat formulated to penetrate, fortify and prepare slick steel troweled non-porous bare concrete. This product is also a superior bonding primer for previously painted deck surfaces.
FOR USE ON: Concrete and wood surfaces usually found in driveways, garages, walkways, patios, pool decks, docks, steps and ramps
Dyco® TUFF GRIP™ is a waterborne epoxy ester tie coat formulated to penetrate, fortify and prepare slick steel troweled non-porous bare concrete. This product is also a superior bonding primer for previously painted deck surfaces.
FOR USE ON: Concrete and wood surfaces usually found in driveways, garages, walkways, patios, pool decks, docks, steps and ramps.
Product Specifications:
PRECAUTION: Do not freeze. Wear protective clothing and eyewear during application of this product. Do not transport on passenger seats or inside passenger compartment of any vehicle. Store product in cargo area of vehicle, and secure with protective cloths to prevent accidental spill damage. Do not store at temperature above 100 °F (37 °C). Do not use in drinking water or food systems.
READ AND FOLLOW ALL DIRECTIONS: Surfaces must be clean, dry and sound. Contaminants such as dirt, dust, grease, wax, oil, soap film, rust, mold, mildew, bond breakers and curing compounds must be removed before application. Loose, chipping and peeling of previous coating must be removed before application. Repair holes and cracks with an appropriate patching material. Clean surfaces with bleach solution [one (1) part bleach to four (4) parts water] and a stiff bristle brush. If mildew is present, treat with a mildew remover. Rinse with clean water and let dry one (1) to two (2) days before application. Do not apply to damp surfaces or when surface temperature is below 50 °F (10 °C) or above 100 °F (37 °C). Do not apply if rain is prevalent. Do not thin.
PREPARING NEW AND PREVIOUSLY COATED SURFACES: Allow new exterior concrete to cure a minimum of 30 days and a minimum of 45 days for new interior concrete before application. Pressure cleaning is recommended. Alternative to acid etching.
APPLICATION: Mix thoroughly before use. TUFF GRIP is a one (1) coat process. Apply one (1) coat evenly with a phenolic core (solvent resistant) medium nap roller, brush or airless sprayer. Do not leave puddles or roller marks. Coverage is 250- 500 sq. ft./gal. depending on surface porosity and application method. Top coat with concrete stain or paint in a minimum of eight (8) hours to a maximum of five (5) days. Dries to touch in two to three (2-3) hours @ 77 °F (25 °C) and 50% Relative Humidity Ready for topcoat in eight (8) hours. Low temperature, high humidity, thick films or poor ventilation will increase these dry times
Refer to Safety Data Sheet for additional health and safety information.
Refer to Product Spec Sheet for additional application details and further information.
- Choosing a selection results in a full page refresh.
- Press the space key then arrow keys to make a selection.